Christie 38-RS1002-01 Návod k obsluze stáhnout pdf (Strana 4)

Manufactured in the U.S.A by IDM Tech, LLC for CryoPen, Inc.

Distributed by CryoPen, Inc

CryoPen

- 4 -

Originated Date: 02.25.2010

Revision Date: 5.1.2012

OM-CT2-01-R6

 Step one: Turn unit off, UNPLUG FROM WALL and allow to defrost.

 Step two: After unit has reached room temperature, approximately 8 hours, unplug the power supply from unit and

remove Pen Cores from the chilling wells.

 Step three: Using the 14” swab that is provided, remove all reservoir solution and water from the chilling wells.

Wells should be completely dry.

 Step four: Remove reservoir tube from the unit, discard old solution and refill to the maximum line (3 pipettes).

 Step five: Dry all Pen Cores with cotton towel. Using the supplied plastic Pipette, fill each chilling well with

reservoir solution (one Pipette full per well). Place 1 pen core into each of the wells. Place remaining two pen cores

in the holding wells.

 Step six: Plug the power supply into the unit and turn unit on (Located on left side of unit). Green light will

illuminate on front of unit. System will be ready for use in approximately 120 minutes. Test Pen Cores for readiness

using the temperature indicator.

The above steps should be followed each time you have a power outage.

 Step one: Turn unit off and UNPLUG FROM WALL outlet/surge protector, wait 3-5 minutes then re-plug electrical

cord into wall outlet/line surge protector and turn system back on. This will allow your system to reset.

 Step two: If unit does not chill properly after this process, turn unit off and follow the steps for a Power Outage

and/or call Technical Support at 1.877.246.3955.

Note: We recommend using a line surge protector to protect this system and your investment.

POWER OUTAGE

POWER SURGE

1 2 3 4 5 6 7 8 9 ... 13 14

Žádné komentáře

Christie 38-RS1002-01 Návod k obsluze Strana 4